Clean bike surface with lacquer thinner or alcohol.
Clean back of Frame Cover with the same cleaner.
Apply double sided tape to the two outer edges of Frame Cover.
Apply a 2" piece of tape above the protruding round nut on bike frame.
Push wires and hoses down as far as possible. Remove backing from 2" tape. Slide Frame Cover into place keeping Cover nearest to the engine as you are installing it.
Line up the hole in the Frame Cover with the protruding nut on the bikes frame. Keeping the outer edges lined up with the frame so it looks straight, press the Frame Cover into the center tape piece.
Keeping the Frame Cover straight, lift right edge of Cover just enough to remove the tape backing.
Press Frame Cover edge onto the bike. Now do the left side the same way.
Complete installation by removing protective backing from Frame Cover. DO NOT use anything that could scratch the stainless steel finish.
